15376 Autoloader ALE: Carrier required to do this proofing command Trendsetter_400/800_Proofing This error should not be seen under normal machine operation. If you see this error please call Creo service. If the cassette is installed properly you should be able to verify that the sensor is working by using the "proof" command. If the senor is not working, check the TEE board, the sensor alignment and the cabling. The carrier was not detected at the start of the calibration procedure. The carrier is not installed properly or the sensors are not working properly. ../commands/proof_cal.xmlCommand: proof cal ../commands/proof.xmlCommand: proof ..\..\ShowAllErrors.htmFirmware 0 Error Index ..\..\ShowAllCommands.htmFirmware 0 Command Index ..\..\ShowAllNVS.htmFirmware 0 NVS Index Updated: Wed Jul 16 19:33:05 2008 PST